There was that video from a few months ago from… Prints with layers I think? That looked at the actual particulate and volatile counts and found that PLA actually gave off very little? Other plastics were much worse.
So remember that the particle counts matter as much as the danger of the particles.
(Disclaimer, that was a video, not a peer reviewed scientific paper)
There was also a video a while back from one maker channel where the guy said that he got some type of nasty poisoning from breathing in fumes from ABS printing. Fortunately ABS isn’t as popular of a material as it once was, now that there are better alternatives, but I’m sure many of them still put out some nasty fumes.
There was that video from a few months ago from… Prints with layers I think? That looked at the actual particulate and volatile counts and found that PLA actually gave off very little? Other plastics were much worse.
So remember that the particle counts matter as much as the danger of the particles.
(Disclaimer, that was a video, not a peer reviewed scientific paper)
Made with Layers (Thomas Sanladerer)
There was also a video a while back from one maker channel where the guy said that he got some type of nasty poisoning from breathing in fumes from ABS printing. Fortunately ABS isn’t as popular of a material as it once was, now that there are better alternatives, but I’m sure many of them still put out some nasty fumes.